Home › Guides › Tighten the belt
How to tighten a walking pad belt
A belt that slips, hesitates or drifts to one side usually needs a few quarter turns of the rear bolts.
By Ryan Caldwell. Updated .
Unplug the pad and find the two bolts at the back end. Turn each one clockwise a quarter turn, the same amount on both sides, then test at a slow walking speed. To center a belt that drifts, run it at about 2 mph and turn the bolt on the side it drifts toward a quarter turn clockwise, waiting a minute between adjustments.
Tighten a slipping belt
- Unplug the pad.
- Turn both rear bolts clockwise a quarter turn each.
- Test at a slow walking speed.
- Repeat in quarter turns until the slipping stops.
Center a drifting belt
- Run the belt at about 2 mph with nobody on it.
- If it drifts left, turn the left bolt a quarter turn clockwise. If it drifts right, turn the right bolt.
- Wait a minute to see the effect before adjusting again.
Still slipping?
A belt that slips when tight is often dry underneath. Try lubricating it. If it still slips, the belt or drive belt may be worn; contact the maker under warranty.
Questions people ask
How tight should a walking pad belt be?
Tight enough that it does not slip or hesitate when you step on it, but loose enough that you can lift the edge a couple of inches at the middle.
Why does my walking pad belt keep moving to one side?
Uneven tension or an uneven floor. Level the pad, then adjust the bolt on the side it drifts toward.